Specifications
2-264 SmartSwitch ATM Switch Reference Manual
RedundancyStatus
RedundancyStatus
(SmartSwitch 6500 Only)
Use RedundancyStatus to display status of automatic TSM/CPU redundancy and CSM redundancy on the switch.
Operators
show
Parameters
This attribute has no input parameters. Just type show redundancystatus at the switch prompt.
Output Parameter Description
[Admin Status] Administrative status of automatic TSM/CPU redundancy (whether or not automatic
TSM/CPU redundancy has been set ON with the RedundancyOn attribute). Possible
values are: Enabled or Disabled. As indicated in the description for the [Oper Status]
parameter, several conditions must be met before automatic TSM/CPU redundancy is
operational, regardless of whether it has been set ON.
[Oper Status] Operational status of automatic TSM/CPU redundancy. Possible values are: Redundant
or Not Redundant. Operational status is Redundant if all of the following are true:
•
A slave TSM/CPU is present.
•
Redundancy is set to ON, using the RedundancyOn attribute.
•
Slave and master modules run the same version of boot load and switch
operating firmware.
Note Some early versions of TSM/CPU might support automatic mirroring of slave
and master configurations (configuration of the slave module is automatically
kept current with the master module) but not CPU switchover. In this case,
operational status is Redundant, but you get the message “TSM/CPU does not
support automatic CPU switchover.”
[Active CPU] Indicates slot location of master CPU.
[Standby CPU] Indicates whether a slave TSM/CPU is present or absent. If the module is present, slot
location is provided.
[Active CSM] Indicates slot location of master CSM.
[Standby CSM] Indicates whether a slave CSM is present or absent. If the module is present, slot location
is provided.