Specifications

2-78 SmartSwitch ATM Switch Reference Manual
IlmiConfig Console Commands
IlmiConfig
Use IlmiConfig to manage ILMI timers specified in ILMI 4.0 and to enable or disable ILMI functions.
Note The following applies to SmartSwitch 6500 only: You can hot-swap TSMs.
Hot-swapping is replacing a module when the chassis is powered up. If you
replace a TSM with another TSM of the same type (same I/O ports), existing
configuration of port parameters is not affected. This includes parameters set
using any of the following attributes: ATMRoute, CACServiceClassBw,
IlmiConfig, NetPrefix, Port, PortConfig, PVC, PVP, ServiceRegistry, SigTimer,
SigStatistics, SSCOPConfig, and SSCOPStatistics. If you replace a TSM with
another TSM of a different type, existing configuration of port parameters is
deleted. The deletion occurs when the new module is plugged into the chassis
backplane.
Operators
modify, show
Parameters
Input Parameter Description Value/Field Size Default
[PortNumber] Port number on the switch. You can
specify a physical or virtual port.
A1 to B4 (physical-2500 family),
A1.n to B4.n (virtual-2500 family),
1A1 to 8B4 (physical-6500),
1A1.n to 8B4.n (virtual-6500),
or All
All
[IlmiAddressRegistration] Controls ILMI address registration. Enable, Disable Enable
[IlmiConnectivity] Controls ILMI connectivity. Enable, Disable Enable
[Timer-S] Timer S in seconds for establishing
ILMI connectivity.
1-65535 1
[Timer-T] Timer T in seconds for checking
ILMI connectivity.
0-65535 5
[Factor-K] Number of K consecutive polls for
which no ILMI response is received
before ILMI connectivity is declared
lost.
0-65535 4