Specifications

CHAPTER 2: LOCAL MANAGEMENT

2-10 WPIM-SY LOCAL MANAGEMENT GUIDE

2.3.2 WPIM-SY Interface Conﬁguration

This screen is accessed through the WAN Physical Conﬁguration screen.

Refer to Figure 2-2 and proceed with the following steps to conﬁgure the

WAN Interface through Local Management.

1. Use the arrow keys to highlight Interface Number. Set the WAN

connection Interface Number by typing the same number found in the

Interfaces field on the WAN Physical Configuration screen into the

Interface Number field, then press ENTER. In this example, the

Physical Configuration screen shown in Figure 2-1 uses Interface 002

for the WPIM-SY WAN connection.

2. Use the arrow keys to highlight Line Coding. Press the SPACEBAR

to select None, then press ENTER.

3. Use the arrow keys to highlight Active Protocol. Press the

SPACEBAR to select PPP, then press ENTER.

4. Use the arrow keys to highlight PPP Type. Press the SPACEBAR to

select BNCP, then press ENTER.

5. Use the arrow keys to highlight the SAVE command. Press ENTER.

The message “Save Done!” appears and Local Management saves the

changes to memory.

The WAN conﬁguration is complete. It takes up to 60 seconds for the

WAN Interface to come out of standby and for communications to begin.

Upon saving this screen, the interface just configured is

assigned to an application port (PT#) in the table on the right

hand side of the screen once the device starts communicating

with the service provider’s switch.

NOTE