Specifications

PPP CONFIGURATION
WPIM-SY LOCAL MANAGEMENT GUIDE 2-9
2.3.1 WPIM-SY Physical Configuration
Begin the WPIM-SY configuration by accessing the WAN Configuration
screen through Local Management (Figure 2-1). Access the WAN
Physical Configuration screen from the Feature Selection screen that first
appears when you enter Local Management. Use the arrow keys to
highlight the WAN Configuration option, then press ENTER. The screen
shown in Figure 2-1 appears. Proceed with the following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the
screen. Press the SPACEBAR to select the WPIM being configured,
then press ENTER.
2. Use the arrow keys to highlight SYNC PORT TYPE. Press the
SPACEBAR to set the Sync Port Type to V.35, RS422, RS232, or
X.21, then press ENTER.
3. Use the arrow keys to highlight FORCE CTS. Press the SPACEBAR
to set to NO, then press ENTER.
4. Use the arrow keys to highlight FORCE DSR. Press the SPACEBAR
to set to NO, then press ENTER.
5. Use the arrow keys to highlight the SAVE command. Then press
ENTER. The message “Save Done!” appears and Local Management
saves the changes to memory.
6. Access the WAN Interface Configuration screen by using the arrow
keys to highlight the WAN Int Config option, then press ENTER.
Set FORCE CTS and FORCE DSR to YES only if the
CSU/DSU does not support these flow control terms.
NOTE