Specifications

CHAPTER 2: LOCAL MANAGEMENT
2-18 WPIM-E1 LOCAL MANAGEMENT GUIDE
The WAN configuration is complete. It takes up to 60 seconds for the
WAN Interface to come out of standby and for communications to begin.
2.5 FRAME RELAY CONFIGURATION
This section provides step-by-step instructions for configuring the
WPIM-E1 to use an E-1 circuit in a Frame Relay environment. This
example assumes the setup shown in figure 2-7 using two MicroMMAC
hubs each with a BRIM-W6 containing a WPIM-E1. Configurations may
vary depending on the hub.
Figure 2-7. Frame Relay Configuration
The following information must be supplied to the service provider.
• LMP type: Q.933-A
Upon saving this screen, the interface just configured is
assigned to an application port (PT#) in the table on the right
hand side of the screen.
NOTE
SITE 1
Telco Cloud
32 Timeslots
(31 customer-usable)
32 Timeslots
(31 customer-usable)
SITE 2
1484_05