Specifications

CHAPTER 2: LOCAL MANAGEMENT
2-18 WPIM-T1 LOCAL MANAGEMENT GUIDE
2.5 FRAME RELAY CONFIGURATION
This section provides step-by-step instructions for configuring the
WPIM-T1 to use a T-1 circuit in a Frame Relay environment. This
example assumes the setup shown in Figure 2-7 using two MicroMMAC
hubs each with a BRIM-W6 containing a WPIM-T1. Configurations may
vary depending on the hub.
Figure 2-7. Frame Relay Configuration
The following information must be supplied to or by the service provider.
• LMP type: ANSI T1.617 Annex D
The line configuration information shown in Table 2-3 must be supplied
by the service provider.
Table 2-3. Telco Configuration Information
Configuration Information
Required by Customer
Information Supplied by
Service Provider
Line Coding B8ZS or AMI
Frame Type ESF or D4
Clock Source Loop Timing or Local Timing
DS-0’s (Timeslots)
Timeslots being used for each end of
the circuit
SITE #1
Telco Cloud
24 Timeslots
24 Timeslots
SITE #2
1482_05