Specifications

FRACTIONAL T-1 CONFIGURATION USING PPP
WPIM-T1 LOCAL MANAGEMENT GUIDE 2-15
2.4.1 WPIM-T1 Physical Configuration
Begin the WPIM-T1 physical configuration by accessing the WAN
Physical Configuration screen through Local Management (Figure 2-1).
Proceed with the following steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the
screen. Press the SPACEBAR to select the WPIM being configured,
then press ENTER.
2. Use the arrow keys to highlight Timeslot View. Press the
SPACEBAR until NEW appears, then press ENTER. The cursor
moves to Timeslot #1 of the Timeslot Configuration Table.
3. Insert an interface number (see NOTE below) into every Timeslot
being used (in the example shown in Figure 2-6, 16 Timeslots are
being used, the rest have zeros in them). Type the number, press
ENTER, then use the arrow keys to highlight the next Timeslot field.
Exit this field by using the arrow keys.The cursor automatically moves
to the T1 Line Coding field.
4. Use the arrow keys to highlight T1 Line Coding. Use the SPACEBAR
to select B8ZS or AMI, then press ENTER.
The value assigned to the Timeslots is the interface being used
for WAN communication. The available interface range is
displayed on the WAN Physical Configuration screen (see
Figure 2-1). You may insert any of the available interface
numbers into the Timeslots.
In the example shown in Figure 2-1, the interface range for
the MicroMMAC with a WPIM-T1 in slot one of the
BRIM-W6 is 2-25. Although any of these values may be used,
Cabletron Systems recommends using the first available
interface number (in this example interface #2).
The following four steps are based on information supplied by
the service provider. Consult the service provider for the
correct settings.
NOTES