Specifications

WPIM-T1 LOCAL MANAGEMENT GUIDE

NOTICE

Cabletron Systems reserves the right to make changes in speciﬁcations and other information

contained in this document without prior notice. The reader should in all cases consult Cabletron

Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL,

INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT

NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR

THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN

ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH

DAMAGES.

CAUTION: THE WPIM-T1 IS INTENDED TO BE INSTALLED IN CSA CERTIFIED/UL LISTED

EQUIPMENT BY A QUALIFIED SERVICE PERSON. CHECK THE EQUIPMENT OPERATION/

INSTALLATION INSTRUCTIONS AND/OR EQUIPMENT MANUFACTURER TO VERIFY/

CONFIRM YOUR EQUIPMENT IS SUITABLE FOR INSTALLED APPLICATION CARDS.

CAUTION: ALWAYS DISCONNECT T1 BOARD (THE ONE WITH THE TELEPHONE PLUG/

JACK) FROM THE TELEPHONE SYSTEM WHEN INSTALLING OR WHEN THE COVERS

ARE REMOVED FROM THE HOST PRODUCT.

CAUTION: APPLY THE ENCLOSED ADHESIVE WARNING LABEL TO THE OUTSIDE OR

INSIDE OF THE EQUIPMENT ENCLOSURE ADJACENT TO THE T1 CARD.

Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005

Printed in the United States of America

Part Number: 9031482-01 November 1995

BRIM

EMM-E6

MicroMMAC

and

NBR-620

are registered trademarks and

WPIM

is a trademark

of Cabletron Systems, Inc.

All other product names mentioned in this manual may be trademarks or registered trademarks of

their respective companies.

Printed On Recycled Paper