Technical data

9031240 E5 Event and Alarm Messages
4-5
NBR-620 Events and Alarms
CsEvFormat/Event000d0109
{d Ò%w- %d %m-, %Y - %TÓ} - Network
conÞguration change reported by {m} ({t}).
Port {I 3} in slot {I 1} has failed
redundancy polling and has switched to a
backup port.
CsPCause/Prob000d0109
The polled device(s) in the redundant
circuit polling list have failed to respond.
The device(s) have failed, been powered
down, or a cable fault from the active port
to the polled device has occurred. Check
the retry count as it may need to be
adjusted on a busy network segment.
Normal collision occurrences may occur
causing the poll packet to not reach its
destination.
CsEvFormat/Event000d010a
{d Ò%w- %d %m-, %Y - %TÓ} - Network
conÞguration change reported by {m} ({t}).
Port {I 3} in slot {I 1} has now become
active as the result of a redundancy
polling failure.
CsPCause/Prob000d010a
The polled device has been communicated
with via a backup port and the port is now
active. The other ports in this redundant
circuit are now designated as backup and
are turned off to prevent data loops on the
network.
CsEvFormat/Event000d010b
{d Ò%w- %d %m-, %Y - %TÓ} - Redundancy
diagnostics of {m} ({t}), indicate that the
redundant link for module {I 1}, port {I 3}
has failed.
CsPCause/Prob000d010b
The cable segment connected to the port
has a cable fault and should be checked
for continuity as soon as possible in the
event the other ports in this redundant
circuit fail and this port is needed.
CsEvFormat/Event000d010f
{d Ò%w- %d %m-, %Y - %TÓ} - User deÞned
trafÞc threshold - {I 1} packets within {I 3}
seconds, exceeded on module {I 5} of {m}
({t}).
CsPCause/Prob000d010f
The packet rate on this module has
exceeded user deÞned limits. The
device(s) attached to this module may
have an application which requires a
large amount of network bandwidth. If
the application required a large amount of
network bandwidth, then a bridge or
router could be used to logically separate
various network segments. Use port level
thresholds to further troubleshoot to a
device level.
CsEvFormat/Event000d0110
{d Ò%w- %d %m-, %Y - %TÓ} -
Error threshold exceeded. An error
threshold of {I 1}% good packets in {I 5}
seconds, exceeded on module in slot {I 7}.
CsPCause/Prob000d0110
This threshold will indicate that a
malfunctioning device is present on this
module or that a cable fault exists. A port
level threshold should be set to further
troubleshoot to the offending node.
Table 4-1. NBR-620 Events and Alarms (Continued)
Event Message Probable Cause Message