- cabletron systems User's Guide SmartSwitch BRIM-A6
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- Installation
- Local Management
- 3.1 Local Management Keyboard Conventions
- 3.2 Using LIM to create PVCs
- 3.3 Using LM to Create PVCs
- 3.3.1 BRIM-A6 Setup Screen Fields
- 3.3.2 BRIM-A6 Setup Screen Commands
- 3.3.3 Using BRIM-A6 Setup Screen Commands
- 3.3.4 Accessing the BRIM-A6 Add/Delete Entry Scree...
- 3.3.5 BRIM-A6 Add/Delete Entry Screen Fields
- 3.3.6 BRIM-A6 Add/Delete Entry Screen Commands
- 3.3.7 Adding a PVC
- 3.3.8 Modifying a PVC
- 3.3.9 Deleting a PVC
- LANVIEW LEDs
- APIM Specifications
- ATM Overview
Appendix A: APIM Specifications
Page A-2 BRIM-A6 User’s Guide
A.3 APIM-22 SPECIFICATIONS
Physical Interface: STS3
Media Type: Category V Unshielded Twisted
Pair
Data Rate: 155 Mbps
Connector Type: RJ45
Typical Link Distance: 100 Meters
The APIM-22 is considered an ATM User Device and therefore has a
different signal pin assignment that the ATM Network Equipment as
specified by the ATM Forum User-Network Interface (UNI)
specification. Figure A-1 shows the pin assignments for the APIM-22.
Figure A-1 APIM-22 Pin Assignments
A.4 APIM-29 SPECIFICATIONS
Physical Interface: OC3
Media Type: Single Mode Fiber
Data Rate: 155 Mbps
Connector Type: SC
Typical Link Distance: 25 Kilometers
1. Transmit +
2. Transmit -
3. N/A
4. N/A
5. N/A
6. N/A
7. Receive +
8. Receive -
1 2 3 4 5 6 7 8
142912
LNK
STS
APIM-22
book Page 2 Thursday, April 18, 1996 2:18 PM