- cabletron systems User's Guide SmartSwitch BRIM-A6
Table Of Contents
- Title Page
- Notice
- Contents
- Introduction
- Installation
- Local Management
- 3.1 Local Management Keyboard Conventions
- 3.2 Using LIM to create PVCs
- 3.3 Using LM to Create PVCs
- 3.3.1 BRIM-A6 Setup Screen Fields
- 3.3.2 BRIM-A6 Setup Screen Commands
- 3.3.3 Using BRIM-A6 Setup Screen Commands
- 3.3.4 Accessing the BRIM-A6 Add/Delete Entry Scree...
- 3.3.5 BRIM-A6 Add/Delete Entry Screen Fields
- 3.3.6 BRIM-A6 Add/Delete Entry Screen Commands
- 3.3.7 Adding a PVC
- 3.3.8 Modifying a PVC
- 3.3.9 Deleting a PVC
- LANVIEW LEDs
- APIM Specifications
- ATM Overview
BRIM-A6 User’s Guide Page 4-1
CHAPTER 4
LANVIEW LEDs
This chapter describes how to use LANVIEW LEDs to monitor BRIM
status and diagnose BRIM problems. Figure 4-1 shows the location of
each of the BRIM-A6 LEDs as well as the APIM LEDs.
Figure 4-1 The BRIM-A6
4.1 BRIM-A6 LEDs
Table 4-1 describes each of the BRIM-A6 LEDs.
Table 4-1 BRIM LEDs
LED Definition
STS
(Status)
Green - Board OK.
Red - Board Error.
Yellow - Standby.
PWR
(Power)
Green (on) - Power is on.
Off - No power.
XMT
(Transmit)
Green - Cells being transmitted.
RCV
(Receive)
Yellow - Cells being received.
APIM
LNK
STS
PWR
XMT RCV
STS
BRIM-A6
131103
book Page 1 Thursday, April 18, 1996 2:18 PM