Specifications

Device Configuration View
Configuration Views ATX Switch
3-4 Management Module Guide
Bandwidth
The estimated bandwidth of the interface measured in bits per second. For
interfaces that do not vary in bandwidth or for which no accurate estimate can
be made, a nominal bandwidth is provided.
Physical Address
The Ethernet (MAC) address of the port.
Operation Status
The current operational state of the port (On, Off, or Testing).
Admin Status
The desired operational state of the port (On, Off, or Testing).
Last Change
The System UpTime value when the port entered its current operational
state.
Queue Length
The length of the outbound queue of packets.
Packet Size
The largest Maximum Transmission Unit (MTU) that can be transmitted or
received by the port, measured in octets.
Double-clicking on any column entry for a particular port accesses the
Interface Configuration view. This view is described below.
Interface Configuration View
You can access the IF Configuration view from the Interface icon in the
Interface Device view. The IF Configuration view provides the following
information:
Admin Status
The desired operational state of the port (On, Off, or Testing). You can change
the Admin Status in this view.
Network Name/Address
Displays the network name and IP address for this ATX Switch.
PPP Point to Point Protocol
SLIP Generic Serial Line IP
Table 3-1. ATX Switch Interface Types (Continued)
Interface Type Description