Specifications

Accessing the Logical or Interface Device Views
Logical Interface Icons
Device Views ATX Switch
2-6 Management Module Guide
Admin Status
You can select the desired operational state of the interface (On, Off, or
Testing).
Last Change
The System UpTime value when the interface entered its current operational
state. This is provided in the format: D + HH:MM:SS, for example, 1+20:40:25
if the ATX Switch has been active for one day and 20 hours, 40 minutes and 25
seconds.
Network Name/Address
The IP Address assigned to the ATX Switch.
Physical Address
The Ethernet (MAC) address of the interface.
Bandwidth
The estimated bandwidth of the interface measured in bits per second. For
interfaces that do not vary in bandwidth, or when no accurate estimate can be
made, a nominal bandwidth is provided.
Packet Size
The largest packet that can be transmitted or received by the port, measured
in octets.
Queue Length
The length of the outbound packet queue, in packets.
Physical Address Label/IF Address Translation Table
Zone (d) of the Interface Icon displays the physical address of the device
interface. Double-click this zone to access the Interface Address Translation
Table. This table cross-references device IP addresses to device MAC
(Ethernet) addresses for selected nodes between networks. Double-clicking on
any column entry opens an address-specific Address Translation Table
Information view.
IP Address Label/Network Information Panel
Zone (e) of the Logical Interface Icon accesses the Network Information Panel.
This panel provides Name, Network Address, and subnet mask information
for the interface for the ATX Switch device. Any of the network information
entries from this panel or the device’s IP address can be displayed on zone (e)
of the Logical Interface Icon. Refer to the Interface Options Panel section of
this chapter.