Specifications

Source Route Group
ATX MIB Reference Guide 6-9
dot1dSrPortEntry {dot1dSrPortTable 1}
Not-Accessible
A list of information for each port of a source route bridge.
dot1dSrPort {dot1dSrPortEntry 1}
Integer Read-Only
The port number of the port for which this entry contains Source Route
management information.
dot1dSrPortHopCount {dot1dSrPortEntry 2}
Integer Read-Write
The maximum number of routing descriptors allowed in an All Paths or Spanning
Tree Explorer frames.
Any value from 0 to 8 may be specified; specifying 0 will cause the unit to return
its default value_.
2
dot1dSrPortLocalSegment {dot1dSrPortEntry 3}
Integer Read-Write
The segment number that uniquely identifies the segment to which this port is
connected. Current source routing protocols limit this value to the range 0
through 4095. A value of 65535 signifies that no segment number is assigned to
this port.
dot1dSrPortBridgeNum {dot1dSrPortEntry 4}
Integer Read-Write
A bridge number uniquely identifies a bridge when more than one bridge is used
to span the same two segments. Current source routing protocols limit this value
to the range 0 through 15. A value of 65535 signifies that no bridge number is
assigned to this bridge.
2.
The unit’s default value is 8; however, in the future, the default value may be changed to
14 in order to conform to the SRT standard.