Specifications

ATX MIB Reference Guide 5-1
CHAPTER 5
FDDI MIB
The ATX supports the FDDI MIB as defined in FDDI Management Information
Base, RFC 1512 (Jeffery D. Case, editor) dated September 1993. The FDDI MIB
is divided into groups of parameters. The individual groups are described in the
subsections below. You may also need to refer to the RFC, since this document
paraphrases the standard MIB in order to provide device specific descriptions.
The access types of some of the parameters have been extended from Read-Only
to Read-Write, indicatd by an asterisk (*); other parameters have been changed
from Read-Write to Read-Only, indicated by a number sign (#). The access type
of all other parameters is as indicated in the standard MIB.
The MIB branch for reaching the SMT group is:
1.3.6.1.2.1.10.
5.1 SMT GROUP
fddi {transmission 15}
This group supports SMT version 7.3. Version 6.2 was supported in release 2.3 of
ATX system software however, it has been deprecated and thus is not included in
this manual.
fddimib {fddi 73}
fddimibSMT {fddimib 1}
fddimibSMTNumber {fddimibSMT 1}
Integer Read-Only
The number of FDDI ports configured in Configuration EEPROM.
NOTE
The value of fdditime is measured in number of nonseconds; in
previous releases it was measured in number of 80
nanosecond units.