Specifications

Chapter 10: Cabletron MIB
10-92 ATX MIB Reference Guide
strunkEntry {strunkTable 1}
Not-Accessible
An entry exists for in this table for each physical interface (port) that is
configured for trunking.
strunkIfIndex {strunkEntry 1}
Integer Read-Only
Identifies the physical interface (port) which is configured for LAN trunking. The
value of this variable corresponds to ifIndex, as well as most of the other port
identification values in related MIBs.
strunkState {strunkEntry 2}
Integer Read-Only
Indicates the trunking condition for this port. Values include:
• off (1) – this link has not been enabled for trunking
• closed (2) – this link has not yet received any trunking PDUs
• oneway (3) – incoming trunking PDUs do not indicate that the ATX’s PDUs
are being successfully received by the far end
• joined (4) – this link is actively participating in the trunk group
• perturbed (5) – this link is actively participating in the trunk group; however,
the transmission of data packets has been temporarily stopped due to a change
in membership of the trunk group
• helddown (6) – an error has been detected and this link is being held out of
service until the error clears
• broken (7) – this link has been configured for trunking but the port is
physically non-operational
strunkRemoteBridgeAddr {strunkEntry 3}
Octet String Read-Only
The MAC address portion of the bridge ID of the remote bridge.
strunkRemoteIp {strunkEntry 4}
IP Address Read-Only
The IP address of the remote bridge, as reported by that bridge for administrative
purposes.