Specifications

Chapter 10: Cabletron MIB
10-76 ATX MIB Reference Guide
10.3.17 Cabletron Protocol Group
sproto {ecs-1 17}
This group specifies which protocols apply to each interface and allows
configuration of bridging-translation between Token Ring and Ethernet for
various protocols.
sprotoTable {sproto 1}
Not-Accessible
This table contains configuration information specifying the types of protocols
used to bridge, route, translate, and filter frames for each port.
sprotoIpxDot3Framing {sproto 2}
Integer Read-Write
If sprotoIpxTranslate is enabled, specifies the type of framing to be used for
NetWare IPX packets on 802.3 networks:
• ethernet8023 (1) - specifies that the 802.3 header is to be used without an
802.2 header
• ethernet2 (2) - specifies that Ethernet-2 framing is to be used, with ethernet
Type 8137
• ethernet8022 (3) - specifies that an LLC header e0,e0,03 is to be used in
conjunction with the 802.3 header.
sprotoEntry {sprotoTable 1}
Not-Accessible
Each entry in this table specifies which protocols are used by a particular port in
the ATX.
sprotoIfIndex {sprotoEntry 1}
Integer Read-Only
Identifies the interface (port) to which this entry’s information belongs. The value
of this variable corresponds to ifIndex, as well as to most of the other port
identification values in related MIBs.