Specifications

ATX Group
ATX MIB Reference Guide 10-49
sifLan {sifEntry 38}
Integer Read-Write
Up to four group identifiers assigned to the port. This variable is used to specify
port groups; the first port group entry is put into the highest order byte and all
other entries follow from high order to low order. The sifLan identifier is only
used by combination filter testing, i.e., for comparisons against filterSrcLan.
Possible values are 0 through 255, for each of the parameter’s four bytes.
sifStatisticsTime {sifEntry 39}
TimeTicks Read-Only
Length of time during which statistics were collected. In particular, the following
statistics may be examined to determine the exact utilization rate of a port:
• ifInOctets
• ifInUcastPkts
• ifInNUcastPkts
• ifOutOctets
• ifOutUcastPkts
• ifOutNUcastPkts
• sifRxChars0s
• sifRxChars1s
sifIpAddress {sifEntry 40}
IP Address Read-Write
The IP address assigned to the port. If this is zero, then the port must learn its IP
address via Reverse ARP or PPP’s IPCP.
sifIpGroupAddress {sifEntry 41}
IP Address Read-Write
Zero, or an IP group address assigned to the port.
sifMaxPacketSize {sifEntry 42}
Integer Read-Write
The Maximum packet size, in bytes (octets), which may be transmitted through
this port. This parameter may not be changed, except for PPP ports, in which
case, changing sifMaxPacketSize automatically causes ifMtu and
pppLinkLocalMRU to change.