Specifications

ATX Group
ATX MIB Reference Guide 10-45
0x0002 TBRIDGE - shows if the port is enabled for Transparent IEEE
802.1d bridging (see sprotoBridge)
0x0004 SBRIDGE - shows if the port is enabled for Source Routing
MAC bridging (see sprotoBridge)
0x0006 SRTBRIDGE - shows if the port is enabled for Source Routing
Transparent bridging (see sprotoBridge)
0x0008 MESH - reserved (always not set)
0x0010 IPROUTE - shows if the port is enabled for IP Routing (see
sprotoIpRoute)
0x0020 NO_BPDU - shows if BPDUs are suppressed; if TBRIDGE is
set, this disables the sending of BPDUs (see
sprotoSuppressBpdus) and keeps the port in forwarding state (this
is to provide interoperability with non-compliant IEEE 802.1d
implementations, however, if the physical topology has any loops,
then LAN segments will most likely be flooded with duplicates of
packets).
0x0040 RIP - shows if RIP is enabled on the port for IP Routing (see
sprotoRip)
0x0080 SRSPAN - shows if auto-span is enabled on the port for SR or
SRT bridging (see dot1dSrPortSTESpanMode)
0x0100 PROXY - shows if Proxy ARP is enabled on the port for IP
Routing (see sprotoArpProxy)
0x0400 IPX routing - shows if the port is enabled for IPX routing (see
sprotoIpxRoute)
0x0800 ARP - shows if ARP is enabled on the port for IP Routing
0x4000 BOOTP - shows if the port is enabled to relay BOOTP and DHCP
packets (see sprotoBootpRelay)
0x8000 FRAME_SWITCH - shows if frame switching is enabled (see
sifFrameSwitching)
0x10000 TRUNKING - shows if port is enabled (see sprotoTrunking)
0x20000 IPM (multicast) - shows if the port is enabled for IP multicast
routing (see sprotoIpMulticast)
0x40000 APPLETALK - shows if the port is enabled for AppleTalk routing
(see sprotoAppleRoute)
These values can be configured through the sprotoTable.