Specifications

Chapter 10: Cabletron MIB
10-16 ATX MIB Reference Guide
configAnyPass {config 2}
Display String Read-Write
The authentication password (0-24 bytes) which must match the community
name in an SNMP PDU, in order for the operation to be performed. A zero length
password indicates that any community name is acceptable.
configGetPass {config 3}
Display String Read-Write
The authentication password (0-24 bytes) which must match the community
name in an SNMP Get PDU (except for Debug or password parameters). A zero
length password indicates that any community name is acceptable. Alternatively,
it is acceptable if the community name matches configAnyPass, defined above.
1
configNMSAddr {config 4}
IP Address Read-Write
The address of the NMS to which Trap PDUs are to be sent. A value of zero
indicates that Trap PDUs should be sent to the NMS last heard from.
configFunctions {config 5}
Integer Read-Only
A bit field which describes the software functions supported by the unit. The
possible values (or combinations thereof) are:
0x0001 NMS - communicates with NMS
0x0002 TBRIDGE - Transparent IEEE 802.1d MAC bridging (if
SBRIDGE is also set, then SRT MAC bridging is supported)
0x0004 SBRIDGE - Source Routing MAC bridging
0x0008 MESH - reserved (originally intended for Cabletron Mesh
Algorithm bridging over WAN ports)
0x0010 IPROUTER - IP Routing
1.
Certain SetRequest PDUs are used for read operations or for acknowledging alarms, and
using configGetPass for the community name is sufficient. Those special conditions
consist of SetRequest PDUs for the following fields: addrFlags, addrMAC, addrPort,
addrOperation (for read-random, read-next, and read-block only), addrIndex,
addrIndexMesh, addrNext, addrAge, addrRxPkts, addrRxChars, addrRxMultiPkts,
addrRxFwdPkts, addrTxPkts, addrTxChars, addrBlockSize, sfddiSrfConditions,
sfddiSmtConditions, addrBlock and addrRptrPort.