Specifications

ATX Group
ATX MIB Reference Guide 10-5
hwDefType {hwEntry 4}
Integer Read-Only
The module type defined for the slot. Certain pre-defined relationships exist. Slot
1 always contains the Packet Processing Engine board. Slots 2-6 are either
unoccupied, or contain IOM boards. Slot 7 is either unoccupied or contains the
Turbo Processor board. If hwDefType does not match hwType, then the module
will not be used, regardless of the value of hwUseMod. Note that hwDefType can
only be changed by rebooting the unit (see the “reboot” group).
hwDiagStatus {hwEntry 5}
Integer Read-Only
Results of diagnostics, when diagnostics were last performed on the module
(whenever a module is released from reset, which is usually at power-up).
Possible values include:
• diag-failed (1) - diagnostics failed
• diag-not-present (2) - module not present (or possibly, diagnostics still
running, or the module’s diagnostics are totally non-responsive)
• diag-passed (3) - diagnostics passed
hwInuse {hwEntry 6}
Boolean Read-Only
Whether the module is currently executing its operational software.
hwDiagCode {hwEntry 7}
Octet String Read-Only
Additional diagnostics information concerning the slot’s module. The meaning of
hwDiagCode depends upon the slot’s module type described by the hwType
parameter.
For the Packet Processing Engine board, any combination of the following errors
may be combined; however, any error (except where noted otherwise) will
prevent the unit from booting:
0x00001 VDRAM and/or Processor error
0x00002 Shared Ram error
0x00004 Rom Checksum error
0x00008 Configuration EEPROM Checksum error
0x00010 Flash EEPROM Bank 0 Checksum error (if Bank 1 is valid, then
the unit will still boot)