Installation guide

AppleTalk Access Problems
5-6
To determine if ATCP is enabled on the access server port, enter the following command.
Substitute the port number for 1:
Local> SHOW PORT 1 ATCP
The ATCP field should be set to Enabled. For more information on configuring and
managing ATCP ports, refer to the Network Access Software Management Guide.
Verify Attached Device Is an End Node
The access server provides connections for devices acting as AppleTalk end nodes.
Connections to routers or other access servers using asynchronous links are not supported.
Verify that the attached host is acting as an AppleTalk end node.
Verify Port Configuration - Dedicated PPP Connection Only
If you are having trouble connecting an attached host that is configured as a dedicated PPP
host, enter the following command. Substitute the port number for 1:
Local> SHOW PORT 1
• Verify that Autobaud is Disabled (if Disabled, Autobaud does not appear in the list
under Enabled Characteristics).
• Verify that Input Speed and Output Speed are consistent with that of the device.
• Verify that Default Protocol is set to PPP.
• Verify that Access is either Local or Dynamic.
For more information on configuring and managing PPP ports, refer to the Network
Access Software Management Guide.