Installation guide

SLIP/PPP Problems
4-8
SLIP Session Not Receiving Input
Solution
If your SLIP session will not transmit or receive, check that the port’s speed and the PC’s
communication port speed match.
If your SLIP session seems to transmit but is not receiving input, enter the following
command. Substitute the number of the port for 1:
Local> SHOW PORT 1 SLIP
Port 1: Development Server: MMS
Host Address: 83.62.18.102 MTU: 1006
Header Compression: Disabled Compression States 16
Verify that the access server port’s host address and the PC Internet address are the same.
For more information on configuring and managing SLIP ports, refer to the Network
Access Software Management Guide.