Installation guide

3-9
Telnet Resource Problems
Telnet Client Hung After Sending AO Character
Solution
If your Telnet session appears to be hung and you previously sent an AO (Abort Output)
character to the host either directly or indirectly, enter the following command on your
access server port to cancel the AO:
Local> SEND TELNET RESUME OUTPUT
When an AO is sent to the host, the access server also sends a timing mark. The host then
returns this timing mark to notify the access server that the AO has been received by the
host. The problem occurs when a host does not return the timing mark to the access server.
If the SEND TELNET RESUME OUTPUT command is entered and an AO has not
been sent, the Telnet session is not affected.
NOTE