Installation guide

Telnet Resource Problems
3-6
Telnet Client Characters Do Not Display on Terminal
Solution
If characters do not display during a Telnet session, enter the following command.
Substitute the number of the port for 1 and the number of the session for 2:
Local> SHOW PORT 1 SESSION 2 CHARACTERISTICS
Port 1, Session 2, Protocol TELNET
Profile: Character
Echo: Locsupr Newline From Term: <CR>
Toggle Echo: ^E Newline From Host: <CRLF>
Binary: Disabled Newline To Term: <CRLF>
Xmit Size: 8 Newline To Host: <CRLF>
Rcv Size: 8 Input Flow Control: Enabled
Signal Req.: Enabled Output Flow Control: Enabled
IP: +s +f ^Y Msg. Verification: Enabled
SYNCH: +s -f ^X Switch Characters: Enabled
AYT: -s -f ^T Quote: None
AO: -s +f ^O
EOR: -s -f None
BRK: -s -f None
Procedure
Do the following:
Step Action
1 Verify that the Echo characteristic is set to Locsupr. (Locsupr causes local
echoing to be suppressed.)
2 If Echo is set to Locsupr, verify the Toggle Echo characteristic to determine its
setting. (In this case, Toggle Echo is mapped to Ctrl/E.)
3 Press the Toggle Echo character.
4 Enter a command line to see if characters are now displayed. If characters still do
not display, see the section Problems with Interactive Devices
(page 10-3) for information on troubleshooting problems with interactive
devices.