Installation guide

Telnet Resource Problems
3-2
Telnet Resource Connection Problems
Introduction
If you experience problems connecting to a Telnet resource, verify the following:
• Internet address
• Internet host name
• Domain name system parameters
• Communication to remote Internet host
• Network access server memory usage
Verify Internet Address
If you are unable to connect to a Telnet resource using an Internet address, enter the
following command:
Local> SHOW INTERNET
State Enabled
Internet Address: 0.0.0.0 (Learning)
Subnet Mask: 0.0.0.0
DHCP: Enabled
TCP Keepalive Timer:120
TCP Keepalive Retry: 8
For more information on specifying the TCP/IP network characteristics for your access
server, refer to the Network Access Software Management Guide.
Step Action
1 Verify that the Internet address and subnet mask are correct.
2 If you are not using the default subnetwork mask, ensure you set the subnet mask
before you set the Internet address.
3 If your Internet address is set to 0.0.0.0, then define your Internet address using
the following command. Substitute your Internet address for 195.1.1.60:
Local> CHANGE INTERNET ADDRESS 195.1.1.60