Installation guide

LAT Service Connection Problems
2-8
If the number of Resource Errors is greater than zero, the access server memory might be
full. Make the following corrections:
Step Action
1 Adjust the group codes to restrict the least-used nodes from being stored in the access
server database. For information on group codes, refer to the Network Access Server
Management Guide.
2 Adjust the access server node, session, and queue limits to restrict memory usage. For
information on managing an access server, refer to the Network Access Server
Management Guide. Reducing the node limit immediately lessens the number of service
nodes stored in the database and frees some memory. The following command shows
how to set the node limit to 100:
Local> CHANGE SERVER NODE LIMIT 100
3 Verify the ports on the access server for sessions in the Disconnecting or Disconnected
state. Enter the following command. Substitute the port number for 5:
Local> SHOW SESSIONS PORT 5
Port 5: Jack Local Mode Current Session: 1 - Session 1:
Disconnecting Interactive EARTH
Then, perform the following:
a. Find the port sessions that have the status Disconnecting or Disconnected.
b. Disconnect these sessions at the port.
c. If there are no other sessions, log out the same ports.