Installation guide

LAT Service Connection Problems
2-6
For services offered by a service node:
At an OpenVMS host, enter the following commands:
$ RUN SYS$SYSTEM:LATCP
LATCP> SHOW CHARACTERISTICS
Node Name: SATRN LAT Protocol Version: 5.2
Node State: On
Node Ident: A VAX 6250 Cluster Member
Incoming Connections: Enabled Incoming Session Limit: 255
Outgoing Connections: Enabled Outgoing Session Limit: 255
Circuit Timer (msec): 80 Keepalive Timer (sec): 15
Retransmit Limit (msg): 8 Node Limit (nodes): 100
Multicast Timer (sec): 30 CPU Rating: 100
User Groups: 60, 70
Service Groups: 60, 70
Service Name Status Rating Identification
EARTH Available 114 D A VAX 6250 Cluster Member
GALAXY Available 114 D A VAX 6250 Cluster Member
-----------------------------------------------------------------
LAT Control Program, Version 5.4-1
------------------------------------------------------------------
LATCP>
In this case, the Service Groups are 60 and 70. Ensure that both the Authorized and
Current Groups defined for the port contain at least one of the service node’s Service
Groups. For more information on group codes, refer to the Network Access Server
Management Guide.
Verify Access Server Memory Usage
The access server has a limited pool of memory. With large networks or many port
sessions, it is possible to run out of memory. When access server memory is filled, the
access server database cannot hold additional information about nodes and services. To
verify that you have a sufficient pool of available memory, enter the following command:
Local> SHOW MEMORY STATUS
High Pool Size: 892943 bytes
High Pool Used: 563516 bytes
Low Pool Size: 52480 bytes
Low Pool Used: 1940 bytes