Installation guide

LAT Service Connection Problems
2-4
To allow both incoming and outgoing connections, use the following command:
LATCP> SET NODE/CONNECTIONS=BOTH
Verify LAT Group Codes
To determine whether a user’s access server port has a group code in common with the
service, enter the following command. Substitute the port number for 1.
Local> SHOW PORT 1
Port 1: Mariellen S. Server: GEMINI
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Local Local Switch: ^^
Backwards Switch: None Name: PORT_1
Break: Local Session Limit: 4
Forwards Switch: ’ Type: Ansi
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script: None
Preferred Service: GALAXY
Authorized Groups: 60, 70
(Current) Groups: 60
Enabled Characteristics:
Autobaud, Autoconnect, Autoprompt, Broadcast, Input Flow
Control, Loss Notification, Message Codes, Output Flow
Control, Verification
If group codes are enabled on the access server port, enter the following command.
Substitute the name of the service for service-name.
Local> SHOW SERVICE service-name
Local -711- Service service-name not known
If the service is not known, verify the group codes that are enabled for the service.