Installation guide

LAT Service Connection Problems
2-2
Connection to Resources Using the LAT Protocol
Fails
Verify the LAT Service Configuration
This section enables you to determine whether a LAT service is defined and properly
configured on your access server.
On the access server that offers the service, enter the following command. Substitute the
name of the service for Local_Service.
Local> SHOW SERVICE Local_Service CHARACTERISTICS
Service: Local_Service
Identification: Device Connected to a Terminal Server
Ports: 15
Rating: 90
Enabled Characteristics:
Connections, Queuing
Verify that the service is set up on the desired ports and connections are enabled. (If
enabled, Connections appears in the list under Enabled Characteristics.) For more
information on configuring and managing LAT services, refer to the Network Access
Software Management Guide.
Verify the LAT Service Node Software
This section enables you to determine whether the LAT software is running on your LAT
service node. Your service node operating system documentation provides details about
the procedure. For OpenVMS systems, refer to the LAT software documentation that
comes with your operating system.