Installation guide

28-5
Messages 1100 – 1208
Local -1204- Illegal Rlogin host specification
Explanation: The Rlogin host name was more than 255 characters.
Action: Specify a valid host name or address. If you did not specify one on the command
line, or on the port settings for default or preferred service, then an internal software error
has occurred. Log out the port, and try again. If the problem persists, reboot the access
server, and contact your authorized service representative.
Local -1205- Rlogin escape sequence too long
Explanation: Escape sequence may only be a single ASCII character.
Action: Use a single character.
Local -1206- Rlogin escape character invalid
If command was SET/DEFINE/CHANGE PORT RLOGIN ESCAPE:
Explanation: Rlogin escape character may not be a lowercase or uppercase letter, or a
single numeral.
Action: Use a control character (for example, Ctrl/A or Ctrl/B) or non-alphanumeric
character (for example, ~, !, @, or #). May only be one character.
If command was SET/DEFINE/CHANGE PORT RLOGIN INPUT/IO:
Explanation: The Suspend Input and Suspend IO characters may not be the same, on a
particular port. They may not be more than one character. Ctrl/D and "." are not valid.
Action: Use different single characters for these Suspend characters.
Local -1207- Rlogin terminal type invalid
Explanation: The way the terminal was specified was not recognized.
Action: Designate the terminal as "VTxxx", where xxx is a number.
Examples: VT100, VT220, VT420
If you have an incompatible terminal, use the default setting of "unknown." Set up your
environment at the remote host to specify the terminal type.
Local -1208- Rlogin suspend sequence too long
Explanation: The Rlogin Suspend sequence may only be a single ASCII character.
Action: Chose a character which is only a single character.