Installation guide

26-9
Messages 900 – 999
Local -960- Available memory n Mbytes
Explanation: In message 960, n is the number of megabytes of memory. This messages is
generated approximately 10 seconds after powering up the access server or after executing
the INITIALIZE command.
Action: No user action is required.
Local -961- [IP] ARP request failed
Explanation: The access server transmits an Address Resolution Protocol (ARP) request
when attempting to load or dump using the TFTP protocol. The access server is trying to
discover the hardware address of the load server and expects an ARP reply from the load
server. If it fails to get a reply after five attempts, the access server generates this message
and restarts the process.
Action: No user action is required. The access server generates this message and restarts
the process.
Local -962- [IP] TFTP Error message received, code: n
or
Local -963- [IP] Illegal BOOTP reply, code: n
Explanation: An error message was received by TFTP or BOOTP.
Action: The following defines the cause of the error as specified by code n:
1=File field too long 5=Bad xid field
2=Bad Giaddr field 6=Bad op field
3=Bad Siaddr field 7=Bad packet length
4=Bad Yiaddr 8=Bad dest port
Local -964- [MOP] Illegal Dump message - Dump aborted
Explanation: The access server has received an illegal dump message from the dump
host. There is a problem with the packet it has received.
Action: Refer to message 914 for more information.