Installation guide

24-13
Messages 700 – 799
Action: For the correct command syntax, refer to the Network Access Software
Commands Reference Guide.
Local -780- Parameter inappropriate for the console port
Explanation: You tried to set a characteristic on the console port that is not applicable (for
example, SET PORT 0 AUTOBAUD ENABLED).
Action: Use the SET/DEFINE/CHANGE SERVER CONSOLE NONE command to
disable the console port.
Local -781- Port(s) in autobaud state not changed
Explanation: You tried to change the port characteristic CHARACTER SIZE, SPEED, or
PARITY for a port that has AUTOBAUD enabled.
Action: Disable AUTOBAUD on the port and reenter the command.
Local -782- Invalid speed
Explanation: You tried to set a speed that the access server does not support.
Action: Refer to your access server hardware documentation for information on supported
port speeds.
Local -783- No services will be seen from port
Explanation: You entered the SET GROUPS command that disabled all current groups.
Action: Verify the group codes. See the section Verify LAT Group Codes
(Chapter 2).
Local -785- Name contains blanks or illegal characters
Explanation: You entered a command containing an illegal service name or an illegal
node name.
Action: Reenter the command with a valid service or node name. For more information on
configuring and managing LAT services, refer to the Network Access Software
Management Guide.
Local -788- Port has dedicated service status
Explanation: You entered a command that cannot be executed because the target port has
a dedicated service.
Action: For more information on configuring security for interactive ports, refer to the
Network Access Software Management Guide.
Local -789- Still disconnecting
Explanation: You attempted an operation that cannot be performed until a previous
DISCONNECT command finishes processing.