Installation guide

24-9
Messages 700 – 799
Local -737- Flash RAM is not installed or not supported
Explanation: You entered a flash RAM command on a system that either does not support
flash RAM or flash RAM is not installed. If flash RAM is installed, it may be
malfunctioning.
Action: If the flash RAM is user installable, ensure that it is installed properly. If you do
not have flash RAM, you cannot use the flash RAM command.
Local -738- Flash RAM is write protected
Explanation: You tried to write to flash RAM that is write-protected.
Action: Set flash RAM to write-enabled.
Local -739- Flash RAM does not contain correct load image
Explanation: You entered a command that requires the access server to reload a specified
image from the flash RAM that was unavailable.
Action: Verify image name.
Local -740- Options FROM, IMAGE, UPDATE not supported
Explanation: These features are not supported by the firmware in your hardware
platform.
Action: None, these options cannot be used for your particular hardware.
Local -741- Invalid password
Explanation: The password must have from 1 to 16 ASCII characters.
Action: Reenter the password.
Local -742- Password verification failed
Explanation: The verification password on a LOCK command did not match the
specified password.
Action: Reenter the command and password.
Local -743- Illegal port name in effect, remote access denied
Explanation: You specified an invalid port name on an attempt to SET PORT ACCESS to
REMOTE or DYNAMIC. Remote service nodes cannot connect to the port using an
illegal port name.
Action: Use the SHOW PORT command to determine the port name. Then, use the
SET/DEFINE/CHANGE PORT NAME command to change the port name.