Installation guide

24-7
Messages 700 – 799
Local -725- Access to node node-name denied
Explanation: The problem might be caused by one of the following:
• The port and service nodes do not have a LAT group code in common or the access
server has the correct authorized groups, but not current groups.
• The access server node limit has been reached.
• The access server has used up its memory.
Local -726- Node node-name not reachable
Explanation: Your CONNECT request specifies a node that is currently unreachable.
Action: Use the SHOW NODES ALL command to see which nodes have the status
Reachable. Then, verify the LAT service configuration
(Chapter 2).
Local-728- Parameter cannot be modified with connection established/pending
Explanation: The SET/CHANGE SERVER commands specify characteristics that cannot
be changed while connections exist at any port.
Action: Wait until all port users end their sessions or use the DEFINE command.
Local -729- Parameter cannot be modified by a SET or CHANGE command
Explanation: You tried to use the SET or CHANGE command to modify a characteristic
that cannot be modified in the operational database.
Action: Use the DEFINE command to modify the characteristic.
Local -730- Temporary resource conflict - please try again
Explanation: An internal resource conflict temporarily prevents execution of a command.
Action: Retry the command.
Local -731- Port not configured for loopback test
Step Action
1 Verify the LAT group codes. See the section Verify LAT Group Codes
(Chapter 2).
2 Increase the access server node limit and try reconnecting. For information on
managing an access server, refer to the Network Access Software Management Guide.
3 Verify access server memory usage. See the section Verify Access Server Memory
Usage (Chapter 2).