Installation guide

Messages 700 – 799
24-6
Local -720- Protocol does not support operation
Explanation: You entered a SET SESSION TELNET or SET SESSION TN3270
command when the current session does not use the referenced protocol.
Action: Resume the session that uses the referenced protocol, returning to the Local>
prompt. Reenter the SET SESSION command.
Local -721- No dedicated service on port n
Explanation: You entered the CONNECT PORT n or a DISCONNECT PORT n
command to a port that does not have a dedicated service defined. These commands apply
only to ports with a dedicated service.
Action: Specify the service name in the CONNECT command or set up a dedicated port.
For more information on configuring and managing interactive devices, refer to the
Network Access Software Management Guide.
Local -722- Server disabled
Explanation: Your CONNECT request does not work because the access server has been
disabled by the INITIALIZE DISABLE command.
Action: Reinitialize the access server and omit DISABLE from the INITIALIZE
command line.
Local -723- AUTOCONNECT and protocol ANY cannot coexist
Explanation: You cannot have AUTOCONNECT ENABLED and PROTOCOL ANY at
the same time.
Action: Use the SET/DEFINE/CHANGE PORT command to specify either
AUTOCONNECT ENABLED or PROTOCOL ANY. Note that AUTOCONNECT is
ENABLED when a dedicated service is specified for a port.
Local -724- Service node connection limit reached
Explanation: You entered the CONNECT or TEST SERVICE command, which caused
the maximum number of virtual circuits allowed on the access server to be exceeded.
Action: CLOSE or DISCONNECT one of your sessions and try again. For more
information on managing your access server as part of the LAT network, refer to the
Network Access Software Management Guide.