Installation guide

24-5
Messages 700 – 799
Local -716- Access to service service-name denied
Explanation: The problem might be caused by one of the following:
• The port and service nodes do not have a LAT group code in common or the access
server has the correct authorized groups, but not current groups.
• The access server node limit has been reached.
• The access server has used up its memory.
Local -717- Session n not established
Explanation: You attempted to use the DISCONNECT or RESUME command for a
session that does not exist.
Action: Use the SHOW SESSIONS command to view active sessions.
Local -718- Session limit reached
Explanation: You entered the CONNECT command for a port that already has the
maximum number of active sessions allowed (as specified by the SESSION LIMIT port
characteristic).
Action: Increase the SESSION LIMIT characteristic on the port or disconnect one of the
active sessions before establishing a new one.
Local -719- Insufficient resources to complete operation
Explanation: The access server could not complete the operation due to memory
problems.
Action: Verify access server memory usage. See the section Verify Access Server Memory
Usage
(Chapter 2).
Step Action
1 Verify the LAT group codes. See the section Verify LAT Group Codes
(Chapter 2).
2 Increase the access server node limit and try reconnecting. For information on
managing an access server, refer to the Network Access Software Management Guide.
3 Verify access server memory usage. See the sectionVerify Access Server Memory
Usage (Chapter 2).