Installation guide

Messages 700 – 799
24-4
Local -714- Preferred service/host has not been defined
Explanation: You entered the CONNECT command without a service name and the
PREFERRED SERVICE characteristic is set to None.
Action: Use the SET/DEFINE/CHANGE PORT PREFERRED command to configure a
preferred service or reenter the CONNECT command with a service name.
Local -715- Service service-name not currently available
Explanation: The problem might be caused by one of the following:
• The Default Protocol for the port is set incorrectly.
• The LAT service node software is not running on any service node offering the service.
• The access server node limit has been reached.
• Group codes are not enabled.
• The access server has used up its memory.
Step Action
1 If you are trying to connect to a Telnet resource, set the Default Protocol characteristic
on your port to TELNET or ANY. The following command shows how to configure
the default protocol for port 1 to TELNET:
Local> CHANGE PORT 1 DEFAULT PROTOCOL TELNET
For information on the Default Protocol characteristic, refer to the Network Access
Software Management Guide.
2 Verify the LAT service node software. See the section Verify the LAT Service Node
Software (Chapter 2).
3 Increase the access server node limit and try reconnecting. For information on
managing an access server, refer to the Network Access Software Management Guide.
4 Verify the LAT group codes. See the section Verify LAT Group Codes (Chapter 2).
5 Verify access server memory usage. See the section Verify Access Server Memory
Usage (Chapter 2).