Installation guide

Messages 700 – 799
24-2
Local -705- Entry entry-id not in queue
Explanation: You specified a nonexistent queue entry in a REMOVE QUEUE or
SHOW/MONITOR QUEUE command.
Action: Use the SHOW QUEUE ALL command to check the queue entries. For more
information on configuring and managing the LAT connection queue, refer to the Network
Access Software Management Guide.
Local -706- Secure operation requires privilege
Explanation: You entered a command that is not available from a nonprivileged or secure
port.
Action: Use the SET PRIVILEGED command to enable privileges on the port. You must
also enter the privileged password.
Local -707- Existing or queued connections prevent operation
Explanation: You entered the CLEAR SERVICE command while there were existing or
queued connections to the service.
Action: Before entering this command, you must disable both queuing and connections to
the service. For more information on configuring and managing LAT services, refer to the
Network Access Software Management Guide.
Local -709- Service service-name not offered by node node-name
or
Local -710- Node node-name not known
Explanation: The service or node name you specified is either unreachable or unknown to
the access server.
Action: Check the LAT service configuration. See the section Verify the LAT Service
Configuration (Chapter 2).
Local -711- Service service-name not known
Explanation: The problem might be caused by one of the following:
• The Default Protocol for the port is set incorrectly.
• The LAT service node software is not running on any service node offering the service.