Installation guide

23-7
Messages 600 – 699
Local -657- Permanent database inaccessible at this moment
Explanation: You attempted to use the DEFINE or CHANGE command with an SNMP
characteristic, but the permanent database could not be accessed due to conflicting access
requests.
Action: Try again later.
Local -658- No resources available at this moment
Explanation: The access server could not complete the SNMP operation due to
inadequate memory availability.
Action: Verify the access server memory usage. See the section Verify Access Server
Memory Usage (Chapter 2).
Local -659- Community name does not exist
Explanation: You attempted to use the CLEAR or PURGE command with a community
name that has not been previously set or defined.
Action: Use the SHOW/MONITOR/LIST SNMP command to view the currently
specified community names.
Local -660- Community data lost, SNMP reset to factory defaults
Explanation: SNMP information has been reset to factory defaults and SNMP
information you have modified has been lost. This can occur if you pressed the reset
button while installing new software or if the SNMP portion of the permanent database is
corrupted (hardware error).
Action: Reset and/or redefine your SNMP community data. If this action fails to correct
the problem, the access server memory that stores the SNMP characteristics is faulty.
Refer to Chapter 29 for service information.
Local -662- No resources - SNMP not enabled
Explanation: The access server could not enable SNMP on the access server due to
inadequate memory availability.
Action: Verify the access server memory usage. See the section Verify Access Server
Memory Usage (Chapter 2).
Local -663- No Internet address - SNMP not enabled
Explanation: You entered a command that cannot be performed until you set the access
server’s Internet address.
Action: Set the Internet address. See the section Verify Internet Address (Chapter 3).