Installation guide

22-3
Messages 500 – 599
Local -550- SLIP not enabled on that port
Explanation: The SLIP characteristic has not been enabled on the access server port.
Action: Enable SLIP on the access server port. Enter the following command. Substitute
the number of the port for 1:
Local> CHANGE PORT 1 SLIP ENABLED
For more information on configuring and managing SLIP ports, refer to the Network
Access Software Management Guide.
Local -554- SLIP address conflicts with address of another interface
Explanation: Another port or network has the same address as the one you are trying to
set.
Action: Use another address or remove the conflicting address from the other port or
network.
Local -555- SLIP address not contained in address of LAN interface
Explanation: The access server does not have an Internet address set or the SLIP address
is not contained in the LAN’s Internet address.
Local -556- Console messages are not output during SLIP sessions
Explanation: You set up a SLIP session on the designated console port; therefore, console
messages are not displayed.
Action: If you would like to have console messages displayed, assign the console to
another port or configure your SLIP session on another port. For more information on
configuring and managing SLIP ports, refer to the Network Access Software Management
Guide.
Local -557- Cannot enable SLIP on MULTISESSIONS port
Explanation: The Multisessions characteristic must be Disabled on SLIP ports.
Action: Disable Multisessions on the access server port. Enter the following command.
Substitute the number of the port for 1:
Step Action
1 Verify that the Internet address has been set on the access server. See the Verify
Internet Address (Chapter 3).
2 If the Internet address is set, modify your SLIP address to have the same subnet
identifier as the access server Internet address. For more information on configuring
and managing SLIP ports, refer to the Network Access Software Management Guide.