Installation guide

Messages 400 – 499
21-4
Local -426- Host name lookup failure
Explanation: The access server cannot find the host name in its database. This error
message is generated for one of the following reasons: Retry Limit reached, Time Limit
expired, or no name server stored in the local cache. DNS cannot send out a query.
Action: Verify Domain Name System (DNS) parameters. See the section Verify Domain
Name System (DNS) Parameters
(Chapter 3).
Local -427- No address associated with name
Explanation: The access server could not locate the host name.
Step Action
1 If you are trying to connect to a LAT service, set the Default Protocol
characteristic on your port to LAT or ANY. Enter the following command.
Substitute the port number for 1:
Local> CHANGE PORT 1 DEFAULT PROTOCOL LAT
For information on using the SET/DEFINE/CHANGE PORT DEFAULT
PROTOCOL command, refer to the Network Access Software Commands
Reference Guide.
2 If you are trying to connect to a Telnet resource, verify that your host name or
Internet address exists.
3 If you are trying to connect to a Telnet resource and you are using a valid host
name or Internet address, the problem might be that the access server cannot
communicate with the name server.