Installation guide

21-3
Messages 400 – 499
Local -411- PING successful: host reachable
Explanation: A PING or TEST TELNET command was successful in reaching the
specified host.
Action: No action is required.
Local -413- Insufficient resources: PING disallowed
Explanation: The PING command cannot be executed due to insufficient resources.
Local -414- PING timed out
Explanation: The 30-second timer expired when the access server did not receive a reply
from the target host.
Action: Retry the PING command. If this command fails again, the target host is
unavailable or unable to accept Telnet connections.
Local -425- Internet host not known
Explanation: The name server does not recognize the host name or Internet address.
Either you did not include the host name in the command, the host name is not in the
access server database, or the host name syntax is incorrect.
Action: Verify the Internet host name. See the section Verify Internet Host Name
(Chapter
3)
.
Step Action
1 Use the SHOW SESSIONS command to determine if a PING session is already
active on the port. Only one PING session is allowed per port.
2 If every port on your access server is intended only for Telnet use, enter the
following command:
Local> CHANGE SERVER NODE LIMIT 1
This command will prevent the access server memory from being filled with LAT
service node information.
3 Verify the access server memory usage. See the section Verify Access Server
Memory Usage (Chapter 2).