Installation guide

Messages 400 – 499
21-2
Local -401- Unsupported function
Explanation: The command was not recognized.
Action: To ensure that you are specifying all of the required command characteristics,
refer to the Network Access Software Commands Reference Guide.
Local -403- Warning - too many characters; input truncated
Explanation: The name you entered for a system contact or system location has been
truncated to the 32-character limit.
Action: Use the SHOW/LIST SYSTEM command to view the truncated name or reenter
the name with fewer characters.
Step Action
1 If every port on your access server is only intended for Telnet use, enter the
following command:
Local> CHANGE SERVER NODE LIMIT 1
This prevents the access server memory from being filled with service node
information.
2 Verify the number of Internet hosts defined locally in the access server’s
operational database. Enter the following command:
Local> SHOW INTERNET HOST LOCAL
If a lot of Internet hosts are defined locally, this might cause memory problems. To
delete locally defined Internet hosts, enter the following command:
Local> CLEAR INTERNET HOST LOCAL
For information on managing your access server as part of the TCP/IP network,
refer to the Network Access Software Management Guide.
3 Verify access server memory usage. See the section Verify Access Server Memory
Usage (Chapter 2).