Installation guide

20-11
Messages 300 – 399
Local -366- Gateway entry checksum error
Explanation: When the access server initialized or rebooted, it detected a gateway entry
checksum error. This means that at least one of the gateway entries in the access server’s
permanent database has been corrupted.
Action: Enter the gateway entries again. If this action fails to correct the problem, the
access server memory that stores the server characteristics is faulty. Refer to Chapter 29
for service information.
Local -367- Conflict between subnet mask and network address
Explanation: The addresses you specified for the subnetwork mask and network address
are invalid together.
Action: Reenter the subnet mask and the Internet address. For more information on
specifying TCP/IP network characteristics, refer to the Network Access Software
Management Guide.
Local -368- Network is down
Explanation: The Internet network interface has not been initialized because the access
server’s Internet address has not been set.
Action: Set the Internet address. See the section Verify Internet Address (Chapter 3).
Local -369- Network is unreachable
Explanation: You attempted to connect to a remote host that is not on your subnetwork
and the gateway to the remote host has not been entered in the access server database.
Action: Use the SET/DEFINE/CHANGE INTERNET GATEWAY command to add the
gateway address for the remote host. For more information on specifying TCP/IP network
characteristics, refer to the Network Access Software Management Guide.
Local -371- Software caused connection abort
Explanation: The access server disconnected the session to the remote host.
Action: Wait and try again later.