Installation guide

Messages 300 – 399
20-10
Local -361- Error deleting gateway entry, entry not known
Explanation: You attempted to delete (CLEAR or PURGE) a gateway that is not in the
access server database.
Action: Use the SHOW INTERNET GATEWAY command to display existing gateways.
For more information on managing your access server as part of the TCP/IP network, refer
to the Network Access Software Management Guide.
Local -362- Gateway entry limit reached
Explanation: The access server limit for gateway entries has been reached. The
permanent database allows 16 gateways; the operational database allows 32 gateways.
Action: Remove a gateway entry to add another. For more information on specifying
TCP/IP network characteristics, refer to the Network Access Software Management Guide.
Local -363- Operation requires Internet address to be set
Explanation: You entered a command that cannot be performed until you set the access
server’s Internet address.
Action: Set the Internet address. See the section Verify Internet Address (Chapter 3).
Local -364- Internet checksum failure, parameters not loaded
Explanation: When the access server initialized or rebooted, it detected an Internet
address checksum error. This means that the Internet address has been corrupted in the
access server memory.
Action: Enter the Internet address again and reboot the access server. If this action fails to
correct the problem, the access server memory that stores the server characteristics is
faulty. Refer to Chapter 29 for service information.
Local -365- ARP entry checksum error
Explanation: When the access server initialized or rebooted, it detected an Address
Resolution Protocol (ARP) entry checksum error. This means that at least one of the ARP
entries in the access server permanent database has been corrupted.
Action: Enter the ARP entries again. If this action fails to correct the problem, the access
server memory that stores the server characteristics is faulty. Refer to Chapter 29 for
service information.