Installation guide

20-9
Messages 300 – 399
Local -357- ARP entry limit reached
Explanation: The access server limit for ARP entries has been reached.
Action: Remove an ARP entry to add another. For more information on specifying
TCP/IP network characteristics, refer to the Network Access Software Management Guide.
Local -358- Server Internet address already set
Explanation: You set an Internet address and then tried to set a subnet mask. When you
set an Internet address, the access server automatically sets the subnet mask to a default
value.
Local -359- Error deleting ARP entry, entry not known
Explanation: You attempted to delete (CLEAR or PURGE) an ARP entry that is not
currently in the access server Address Resolution Protocol’s (ARP) database.
Action: Use the SHOW INTERNET ARP ENTRY command to display the Internet ARP
entries. For more information on managing your access server as part of the TCP/IP
network, refer to the Network Access Software Management Guide.
Local -360- Gateway entry already exists
Explanation: You attempted to enter a gateway that already exists in the access server
database.
Action: Use the SHOW INTERNET GATEWAY command to display existing gateways.
For more information on managing your access server as part of the TCP/IP network, refer
to the Network Access Software Management Guide.
Step Action
1 If you are not using the default subnetwork mask, define your subnet mask using the
following command. Substitute the value of your subnetwork mask for 255.255.0.0:
Local> DEFINE INTERNET SUBNET MASK 255.255.0.0
2 Initialize the access server. For more information on the INITIALIZE command,
refer to the
Network Access Software Commands Reference Guide.