Installation guide

Messages 300 – 399
20-6
Local -326- Must first enable ports on this listener
Explanation: A listener cannot be enabled because it has no physical ports associated
with it.
Action: Enter the following command on the access server that offers the Telnet listener.
Substitute the number of the Telnet listener for 2014:
Local> SHOW TELNET LISTENER 2014
Listener TCP-port: 2014 Listener Type: TELNET
Identification: "Telnet Printer"
Ports: 4
Connections: Enabled
IP Address
0.0.0.0 (will default to server’s IP address)
Verify that Connections are Enabled and the Telnet listener is configured on the correct
port. For more information on configuring a printer for access through a Telnet listener,
refer to the Network Access Software Management Guide.
Local -328- Cannot do this while listener has active server connections
Explanation: A listener cannot be disabled because it has active connections to physical
ports.
Action: You must log out these ports or terminate those jobs before the listener can be
disabled.
Local -329- ID too long
Explanation: You tried to use the SET/DEFINE/CHANGE command with an ID for a
Telnet listener that exceeded the maximum supported ID length (40 characters).
Action: Reenter the ID with a length between 1 and 40 characters.
Local -330- Cannot do this while listener is enabled
Explanation: You attempted to change a port list of an enabled Telnet listener.
Action: Disable the listener before modifying the port list.
Local -331- Invalid TCP port number
Explanation: You entered a Telnet listener command specifying an invalid TCP port
number.
Action: Reenter the command specifying a valid TCP port number. For more information
on configuring a Telnet listener, refer to the Network Access Software Management Guide.