Installation guide

20-3
Messages 300 – 399
Local -307- Invalid operation on a Telnet server session
Explanation: A command that is valid for a Telnet client connection was entered on a
Telnet server connection.
Action: For more information on valid commands, refer to the Network Access Software
Commands Reference Guide.
Local -308- Invalid operation on a Telnet client session
Explanation: A command that is valid for a Telnet server connection was entered on a
Telnet client connection.
Action: For more information on valid commands, refer to the Network Access Software
Commands Reference Guide.
Local -309- Type-ahead not yet processed, please try again
Explanation: A Telnet command was entered for a connection on which type-ahead is
queued, and this command is valid only when there is no type-ahead.
Action: Clear the line to the peer with a SEND SYNCH command or enter the command
again.
Local -310- Character already in use
Explanation: A Telnet command was entered that maps a character to a Telnet function,
and the character is already mapped to a Telnet function.
Action: Enter the following command. Substitute the number of the port for 1 and the
number of the session for 2:
Local> SHOW PORT 1 SESSION 2 CHARACTERISTICS
Port 1, Session 2, Protocol TELNET
Profile: Character
Echo: Remote Newline From Term: <CR>
Toggle Echo: ^E Newline From Host: <CRLF>
Binary: Disabled Newline To Term: <CRLF>
Xmit Size: 8 Newline To Host: <CRLF>
Rcv Size: 8 Input Flow Control: Enabled
Signal Req.: Enabled Output Flow Control: Enabled
IP: +s +f ^Y Msg. Verification: Enabled
SYNCH: +s -f ^X Switch Characters: Enabled
AYT: -s -f ^T Quote: None
AO: -s +f ^O Terminal Type: Unknown
EOR: -s -f None
BRK: -s -f None