Installation guide

Messages 300 – 399

20-2

Local -303- Insufficient resources to complete Telnet connection

Explanation: The access server could not complete the Telnet connection due to memory

problems.

Local -304- Telnet option negotiation in progress, please try again

Explanation: A Telnet command was entered that affects a Telnet option currently being

negotiated.

Action: Wait until the option completes negotiation and try again. Enter the MONITOR

PORT STATUS command to monitor the option negotiation.

Local -305- Telnet session was not established

Explanation: A Telnet command was entered for a connection that is not established. The

command entered is valid only for established connections.

Action: Establish a Telnet connection and retry the command.

Local -306- Insufficient resources to complete Telnet operation

Explanation: The command failed due to insufficient memory.

Step Action

1 If every port on your access server is intended only for Telnet use, enter the

following command:

Local> CHANGE SERVER NODE LIMIT 1

2 This command will prevent the access server memory from being filled with LAT

service node information.

3 Verify access server memory usage. See the section Verify Access Server Memory

Usage

(Chapter 2).